April 27th, 2010 |
xumi |
Question:
I have a setup with a remote office (192.168.10.x range) that is connected to our main office (192.168.1.x range) via a VPN tunnel through two cisco routers (877 models).
People on the 192.168.10.x network can find anything at the main office on our primary gateway 192.168.1.1, we have a secondary gateway 192.168.1.254 (cisco 851) that needs [...]
April 23rd, 2010 |
xumi |
Question:
Hello,
We have an AP running 12.3 and would like to change our WEP encryption to WPA. Currently we have a two SSID’s one for visiting business guests,”green”, the other SSID “red” for our in-house staff.
Thank you for your help
Solution:
Here you go. I can walk you through the gui too if you want. AES-CCM is the [...]
April 21st, 2010 |
xumi |
Question:
i am doing frame relay in GNS, not able to configure this toplogy.
Solution:
Well though you didn’t show your router configs, I am assuming you did not configure the frame-relay mapings which are require in a point-to-multipoint config as shown in your diagram. Configure the frame-relay mappings as shown below and you should should be ok. [...]
April 21st, 2010 |
xumi |
Question:
plz explain me NAT in detail
a – What is NAT, use of NAT
b – What is Static NAT
c – What is Dynamic NAT
Solution:
Network Address Translation.
Static is a type of NAT in which a private IP address is mapped to a public IP address, where the public address is always the same IP address (i.e., it [...]
April 17th, 2010 |
xumi |
Question:
HI Experts ,
please can you explain what they mean in ( Non-blocking) switch
i need full details
thanks
Solution:
A network switch that can handle the theoretical maximums that might be thrown at it. For example, say you have an 8-port 100 Mbps switch. Each port is rated for 200 Mbps for full-duplex. Multiply by 8 ports. The switch [...]
April 16th, 2010 |
xumi |
Question:
On a cisco WS-C3560G-48 , can the temperature that displays in the dashboard be change to Fahrenheit instead of Celsius.
Solution:
Nope
April 15th, 2010 |
xumi |
Question:
I have a Cisco ASA5510 that I am trying to connect via VPN (Cisco Client). I can connect and I get the correct IP address (192.168.10.226-192.168.10.230) and I get the correct subnet 255.255.255.0. However for Default Gateway I get 192.168.10.1 and I need to be getting 192.168.10.101 so that I can talk with the other [...]
April 10th, 2010 |
xumi |
Question:
We are getting prepared to replace all our current switches with new Cisco 3750 switches and there are roughly 20-30 switches to be installed and set-up. I am looking for a document or guidelines/best practices to burn-in the switches for a 1 week time frame and also how to stage it? Does anyone have any [...]
Question:
I am trying to decipher the ip addresses here as they are having a steady impact on my network and causing me to repeatedly go over my bandwidth threshold. Right-now for troubleshooting purposes I ran ‘ sho ip flow top-talkers’ (See attachment) with only one computer online and one switch, and one router (cisco 877). [...]
Question:
Sorry for this question, I guess that the answer surely is clear as the sun when you know what you’re doing, which I am clearly not at the moment!
But I can not in any way connect to the internet while using the Cisco IPsec VPN with Cisco VPN Client.
I can ping local devices, but it [...]